This will clear any DTCs that are currently active or stored in the PCM. *Example: KEY IN (OFF) – RUN – OFF – RUN – OFF – RUN – OFF – RUN – OFF – RUN Note: The RUN position is TWO clicks while the ACCESSORY position is only ONE click. Leave in the RUN position on the FIFTH cycle.

Put the key in the ignition with doors closed.Ĭycle the key FIVE times from the OFF position to the RUN position without cranking the engine.

NEXIQ VXTRUCKS V8 USB Link) to clear the codes. In that case, it is best to use an OBD-II scanner (e.g. diagnostic adapter compatible with Insite software (Nexiq USB Link, Dearborn DPA. contact if you dont have any software An interface (e.g. xx or 8.5.xx or calterm software with insite 8.7. This makes the ECU (engine control unit) not look for these structures or fault codes in relation to the DPF (diesel particulate filter). We delete dpf def egr scr for New Cummins BKR CM2450 X124B engine. MAX TUNE DPF Delete This is our DPF delete and is only the software only, this will remove regeneration structures and fault codes from the ecu software. NOTE: Depending on which flash is on your PCM, there is a chance that this procedure will not work. We provide the best CUMMINS X15 BKR DPF Delete by Remote Tuning Service. FUEL ECONOMY & PERFORMANCE EGR DELETE DPF DELETE VGT DELETE: Cummins: ISB 6. How to clear DTCs (check engine light) on Cummins Insite without a code reader: With the Cummins DPF delete tuning loaded into Your ECM, the entire regen system will be disabled & You will be able to straight pipe Your exhaust. You will be asked to turn the key off, and click a button, then key on Select “Erase all Faults” and follow the instructions. How to clear fault codes on Cummins Insite Pro:Īfter you connect to the ECM with Insite, click the “Fault Codes” tab on the left.Īfter the codes are displayed, highlight one of them & right-click on it. Cummins Insite 8.1 crack is verified to clear fault codes without any issue.

Dpf delete with cummins insite software